Olympus DS-660 Instructions Manual page 45

2
1
Hook
Connecting to your PC using the cradle
Place the recorder on the cradle
1
Insert end A of the USB cable to your PC's USB
port or USB hub.
2
Connect the end b of the USB cable to the cradle.
3
Make sure that the recorder is off, and place it in
the cradle.
When you place the recorder on the cradle, 1 insert the
recorder so its bottom slot meets the hook on the front of
the cradle (at the low end). 2 Hold the top of the recorder
and push it against the cradle until it clicks.
"REMOTE" is displayed on recorder if the USB cable is
connected.
Remove the recorder from the cradle
4
Make sure that the recorder's record/play
indicator lamp isn't flashing, and remove the
recorder from the cradle.
Hold the cradle with your hand, and raise the recorder from
the top end to remove it from the hook, as shown in the
illustration.
5
Disconnect the USB cable.
........................................................................................................
Notes
• Do not touch the connection point on the front of the cradle (at the
low end), as that may cause bad connection.
• The cradle does not have the recharging function.
45