Licensing Information; Information To User - Shure PGX Quick Start Manual

CERTIFICATION
PGX1, PGX2, PGX4
This Class B digital apparatus complies with
Canadian ICES-003.
Cet appareil numérique de la classe B est conforme
à la norme NMB-003 du Canada.
Meets requirements of EMC standards EN 300 422
Parts 1 and 2 and EN 301 489 Parts 1 and 9.
Meets essential requirements of European R&TTE
Directive 99/5/EC, eligible to bear the CE mark.
PGX1, PGX2
Certified under FCC Part 74. (FCC ID:
DD4PGX1A, DD4PGX2A, DD4SLX1, DD4SLX2).
Certified by IC in Canada under RSS-123 and RSS-
102. (IC: 616A-SLX1, 616A-SLX2).
PGX4
Approved under the Declaration of Conformity
(DoC) provision of FCC Part 15. Certified in
Canada by IC to RSS-123. (IC: 616A-PGX4A,
616A-PGX4B, 616A-PGX4C, 616A-PGX4D).
Operation of this device is subject to the follow-
ing two conditions: (1) this device may not cause
interference, and (2) this device must accept any
interference, including interference that may cause
undesired operation of the device.
The CE Declaration of Conformity can be obtained
from Shure Incorporated or any of its European
representatives. For contact information please visit
www.shure.com
The CE Declaration of Conformity can be obtained
from: www.shure.com/europe/compliance
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Wannenacker Str. 28
D-74078 Heilbronn, Germany
Phone: +49 7131 72 14 0
Fax: +49 7131 72 14 14
Email: EMEAsupport@shure.de

LICENSING INFORMATION

Licensing: A ministerial license to operate this
equipment may be required in certain areas.
Consult your national authority for possible require-
ments. Changes or modifications not expressly
approved by Shure Incorporated could void your
authority to operate the equipment. Licensing of
Shure wireless microphone equipment is the user's
responsibility, and licensability depends on the
user's classification and application, and on the se-
lected frequency. Shure strongly urges the user to
contact the appropriate telecommunications author-
ity concerning proper licensing, and before choosing
and ordering frequencies.

INFORMATION TO USER

This equipment has been tested and found to com-
ply with the limits for a Class B digital device, pursu-
ant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harm-
ful interference to radio communications. However,
there is no guarantee that interference will not occur
in a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the fol-
lowing measures:
• Relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
• Consult the dealer.
Note: EMC conformance testing is based on the
use of supplied and recommended cable types.
The use of other cable types may degrade EMC
performance.
Changes or modifications not expressly ap-
proved by the manufacturer could void the
user's authority to operate the equipment.
61