Multiple System Setup; Locking And Unlocking Controls - Shure PGX Quick Start Manual

Multiple System Setup

Use the following steps to ensure the best performance when in-
stalling multiple wireless systems at the same location.
1. Turn all receivers on and all transmitters off.
Note: Turn on any other digital equipment that could cause
interference during the performance so it will be detected during
the frequency scans in the following steps.
2. Make sure the group number is the same for all receivers (see
Manual Group Selection).
3. Perform a scan using the first receiver.
4. Turn on the first transmitter and sync it to the receiver.
5. Repeat for each system.
• Important: After syncing each transmitter, leave it on so that
scans from the other receivers will not select that channel.
• Be sure only one transmitter IR port is exposed when
synchronizing each system.
Manual Channel and Group Selection (receiver only)
Using the receiver to scan for a channel
is the best way to find the best frequency
for your system. However, for multiple
system setup, you may need to manually
set the group number.
1. Press and hold the channel button.
2. Hold the button until the channel or
group display begins flashing.
3. Release and press the button again to
advance the setting.
At the desired channel or group num-
ber, wait for the flashing to stop. This
activates the new setting.
4. Transfer the new frequency setting
to the transmitter using the automatic
sync function.

Locking and Unlocking Controls

Locking the system controls prevents accidental muting or
channel adjustment during performances.
Transmitter
To lock the controls: With the transmitter off, hold
the power button down until the green LED flashes (~5
seconds)
To unlock the controls: With the transmitter on, hold
the power button down until the green LED flashes (~5
seconds)
4
group display
3 s
select
channel
channel
channel
Receiver
To lock the channel: Hold the chan-
nel button until the numbers flash (~10
seconds)
To unlock the channel: Hold the channel
button until the numbers flash (~5 seconds)
channel
channel display
6 s
select
channel
channel channel
channel