Removing The Vga/Power Board; Replacing The Vga/Power Board - Dell Inspiron N5110 Service Manual

Back to Contents Page
VGA/Power Board
Dell™ Inspiron™ N5110 Service Manual
Removing the VGA/Power Board
Replacing the VGA/Power Board
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is
not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery (see
computer.
Removing the VGA/Power Board
1. Follow the instructions in Before You
2. Remove the display assembly (see
3. Follow the instructions from
4. Remove the hinge cover (see
5. Carefully ease the connectors on the VGA/Power board out of the slots in the base cover, and lift the VGA/Power Board off the base cover.
1 VGA/Power Board
Replacing the VGA/Power Board
1. Follow the instructions in Before You
2. Align the connectors on the VGA/Power board with the slots on the base cover and place it on the base cover.
3. Replace the hinge cover (see
4. Follow the instructions from
5. Replace the display assembly (see
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
Back to Contents Page
Begin.
Removing the Display Assembly).
step 2 to step 11 in Removing the System
Removing the Hinge Cover).
Begin.
Replacing the Hinge Cover).
step 6 to step 16 in Replacing the System
Replacing the Display Assembly).
Removing the
Board.
Board.
Battery) before working inside the