Display Cable - Dell Inspiron N5110 Service Manual

1 display back cover
3 screws (8)
7. Make a note of the display cable and Mini-Card antenna cables routing and remove them from the routing guides on the display back cover.
8. Turn the display panel over and place it on a clean surface.
9. Remove the display cable (see
10. Remove the display-panel brackets (see
Replacing the Display Panel
1. Follow the instructions in Before You
2. Replace the display-panel brackets (see
3. Replace the display cable (see
4. Connect the camera cable to the connector on the camera module.
5. Route the display cable and Mini-Card antenna cables through the routing guides on the display back cover.
6. Align the screw holes on the display panel with the screw holes on the display back cover and replace the eight screws.
7. Replace the display bezel (see
8. Replace the display assembly (see
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
Display Cable
Removing the Display Cable
1. Follow the instructions in Before You
2. Remove the display assembly (see
3. Remove the display bezel (see
4. Remove the display panel (see
5. Lift the tape that secures the display cable to the display-board connector and disconnect the display cable.
2 display panel
Removing the Display Cable).
Removing the Display-Panel
Begin.
Replacing the Display-Panel
Replacing the Display Cable).
Replacing the Display Bezel).
Replacing the Display Assembly).
Begin.
Removing the Display Assembly).
Removing the Display Bezel).
Removing the Display Panel).
Brackets).
Brackets).