Alcatel-Lucent OmniSwitch 6900 Hardware User's Manual page 27

Chassis and Power Supplies
5 Once the holes are aligned, the second person should insert a screw through the bottom hole on each
flange. Tighten both screws until they are secure.
6 From the back of the chassis and with the flanges facing out, insert the slide-in braces into the slot rails
until they meet the rack posts.
7 The chassis installation should be level. Be sure that the holes and flanges of the slide-in brace are
aligned with the corresponding holes at the front of the rack.
8 Once the flanges are aligned, install the remaining screws in all four flanges. Be sure that all screws are
securely tightened.
OmniSwitch 6900 Hardware Users Guide September 2011
Rack-Mounting
page 2-11