Settings On The Programming Mode - Panasonic KX-NS1000 User Manual

3.1.2 Settings on the Programming Mode

3.1.2 Settings on the Programming Mode
You can programme features using the programming mode for a PT or PS.
–
Setting Features
–
Clearing Features
•
To exit at any time, lift the handset.
•
To enter the programming mode when using a PS, refer to the documentation for your PS.
•
For KX-UT series SIP phone users and S-PS users: You cannot programme the following
features using a KX-UT series SIP phone or an S-PS. These features are programmed via
Web Maintenance Console. For more information, consult your System Administrator.
•
For KX-NT511 users:
Since there is no PROGRAM button on a KX-NT511, press and hold flexible button 1, 2, or
3 instead.
Setting Features
The default settings are shown in bold letters. For later reference, place a check mark in the boxes below to
indicate your customised setting.
Notice
The default value may vary depending on country/area.
To enter the programming mode
PROG.
OR
PAUSE
Press PROGRAM
or PAUSE.
Item
Your extension information
Display Contrast Selection
Preferred display contrast
level from the 4 levels
available
302 User Manual
programming
input
Follow
Press ENTER
or STORE.
programming
input.
Programming
Input
0 0
*1
0 1
To programme
selection &
OR
parameter
Follow Selection
& Parameter.
Selection & Parameter
The display shows your PT or PS's extension number.
<Example>
Ext 101
1
2
3
4
To exit
PROG.
OR
OR
PAUSE
Press PROGRAM
Press ENTER
or PAUSE.
or STORE.
Light
Little Light
Little Dark
Dark