Recording And Using Logs (Log Mode); Recording And Saving Logs - Olympus Stylus TG-Tracker Instruction Manual

Recording and using logs (LOG mode)

While the power switch is in the LOG position, the camera will log
GPS and other sensor data (P. 22). Logs can be downloaded for use
with the OLYMPUS Image Track (OI.Track) smartphone app.

Recording and saving logs

Rotate the power switch to LOG.
• Log recording will start. The indicator lamp lights
green during recording.
• To switch to the shooting display, rotate the power
switch to ON.
• Log recording does not function if no card
inserted.
• The camera automatically terminates log data acquisition and recording when
the battery runs low. Rotate the power switch to OFF to save the log.
• In LOG mode, the camera draws on the battery continuously to acquire
location data.
• An altitude (water depth) track can be viewed in the altitude (water depth) log
display (P. 23). The camera can not display other track logs.
• No additional log data can be recorded after temporary memory buffer used to
store log data fills. If the buffer fills, rotate the power switch to OFF to save the
log data to the card.
Saving logs
The current log is saved to the card when the power switch is rotated to
OFF.
• A message is displayed in the monitor when the
power switch is rotated to or through the OFF
position. If 10 seconds pass or you press OK
while the message is displayed, log recording will
end and the log will be saved to the card. If you
rotate the power switch to LOG or ON before the
10 seconds are up, log recording will continue
and the log will not be saved to the card.
• [Busy...] is displayed in the monitor while the log is saved. Do not remove the
card while this message is displayed. Removing the card before the operation
is complete could result in loss of the log file or in damage to the camera or
the card.
20 EN
Continue LOG
Exit 10