Video Input; Input Source Selection (Video, S-Video) - Sanyo PLC-WL2503 Owner's Manual

Video Input

Choose Video or S-video by pressing the VIDEO button
or the S-VIDEO button on the remote control or press the
INPUT button on the top control.
Before using these buttons, correct input source should be
selected through Menu operation as described below.
Top Control
INPUT button
1
Press the MENU button to display the On-Screen
Menu. Use the Point
then press the Point
2
Use the Point
S-video and then press the SELECT button.
When video input signal is connected to the
Video
VIDEO jack, select Video.
When video input signal is connected to the S-
S-video
VIDEO jack, select S-video.
Note:
When the Input Search function is set to On 1 or On 2 in
the Auto setup function, the input signal will be searched
automatically (p.45).
Downloaded From projector-manual.com Sanyo Manuals

Input Source Selection (Video, S-video)

Direct Operation
Computer 1
Computer 2 *
Menu Operation
buttons to select Input and
▲▼
or the SELECT button.
►
buttons to select either Video or
▲▼
Remote Control
COMPUTER 2 can not be selected when using
*
the COMPUTER IN 2/ MONITOR OUT terminal
as MONITOR OUT output.
HDMI
Video
S-video
Input Menu
VIDEO button
HDMI
Video
S-VIDEO button
S-video
ASPECT
37