Disassemble The Lcd Module; Remove The Lcd Bezel - Lenovo 100S Chromebook-11IBY Hardware Maintenance Manual

Figure 21. Remove the touch pad holder
Step 3. Remove the three screws
arrow 7 .
Figure 22. Remove the touch pad bracket
Table 9. Screw specifications — removing the LCD module
Screw Specifications
label
4
M2.5 ×2 mm, flat-head, nylon-coated
6
M2.5 ×5 mm, flat-head, nylon-coated
Refer to Table 3 "Part numbers for FRUs (CRUs)" on page 22 to look up the Lenovo part numbers of the
following replacement parts:
Touch pad module

Disassemble the LCD module

The LCD module as a whole is not a FRU. It contains FRUs as its components. Before disassembling the
LCD module, make sure it has been detached from the base cover. Refer to "Remove the system board
and the DC-in cable" on page 31 for instructions.

Remove the LCD bezel

Step 1. Insert a pry bar between one inner side of the LCD bezel and the LCD panel and then carefully
pull the LCD bezel outwards. Repeat this action along the inner edges of the LCD bezel until all
hooks that secure the LCD bezel are detached.
Step 2. Remove the LCD bezel
34
Hardware Maintenance Manual
6 , and then remove the touch pad bracket in the direction shown by
1 .
Color Torque
Black 3.7 – 4.0 kgf-cm
Black 3.7 – 4.0 kgf-cm