Refer to "Major FRUs and CRUs" on page 30 to look up details about the following replacement part:
touchpad assembly
conductive tape
Disassemble the LCD module
The LCD module as a whole is not a FRU. Instead, it contains FRUs as its components. Before
disassembling the LCD module, make sure it has been detached from the upper case. Refer to "Remove the
upper case (with keyboard)" on page 47 for instructions.
Remove the LCD panel
Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 36
"Remove the battery pack" on page 37
"Remove the upper case (with keyboard)" on page 47
Step 1.
Insert a pry piece under the lower inner side of the LCD bezel and then carefully pull the LCD bezel
outwards. Repeat this action along the inner edges of the LCD bezel until all hooks that secure the
LCD bezel are detached.
Figure 36. Pull the inner sides of the LCD bezel
.
Chapter 5
Removing a FRU or CRU
51