Remove The Upper Case; Disassemble The Lcd Module - Lenovo V14 Gen 2 Hardware Maintenance Manual

Step 3. Rotate the LCD unit to an angle of more than 90 degrees and place the computer on a flat surface
as shown. Remove four screws and then remove the LCD module.
Figure 33. Remove four screws and then remove the LCD module
Screw specifications
M2.5 x L5

Remove the upper case

Make sure the following FRUs (CRUs) have been removed.
"Remove the lower case" on page 34
"Remove the hard disk drive (HDD) module" on page 35
"Remove the battery pack" on page 37
"Remove the solid-state drive (SSD) module" on page 37
"Remove the Wi-Fi card" on page 39
"Remove the CMOS battery" on page 40
"Remove the memory module" on page 41
"Remove the thermal module" on page 42
"Remove the I/O board module" on page 43
"Remove the system board and the touchpad board cable" on page 45
"Remove the LCD module" on page 47
Go to https://support.lenovo.com/partslookup
part:
Upper case

Disassemble the LCD module

The LCD module as a whole is not an FRU. Instead, it contains FRUs as its components. Before
disassembling the LCD module, make sure it has been detached from the upper case.
48
Hardware Maintenance Manual
Number of screws
4
to look up the Lenovo part number of the following replacement