Motorola SBG940 Quick Installation Manual page 6

6 SBG940 Wireless Cable Modem Gateway
Connecting to the Cable Outlet Using a Splitter
Connecting an SBG940 to the same cable outlet as a TV requires a
5 to 900 MHz splitter and two additional coaxial cables. If a coaxial cable is
already connecting your TV to the cable wall outlet, disconnect it from the TV.
1
Connect one end of a coaxial cable to the cable TV wall outlet and connect
the other end to the splitter input.
2
Connect one end of a second coaxial cable to the splitter output and
connect the other end to your TV.
3
Connect one end of a third coaxial cable to the other splitter output and
connect the other end to the cable connector on your SBG940.
4
Connect one end of the AC power cord into the power connector on the
SBG940 and plug the other end into an AC wall outlet, surge protector,
or UPS. This turns the SBG940 on.
If, after a few minutes, the power, DS, US, and ONLINE lights on the front
panel light solid green, continue with Section B, C, or D. Otherwise,
contact your cable provider and provide your MAC address.