Philips S91 series Manual page 25

6 Place the retaining ring holder on the retaining ring (1), place it on the
shaving head (2) and turn it clockwise (3) to reattach the retaining ring
(Fig. 64). Repeat this process for the other retaining rings.
- Each retaining ring has two recesses that fit exactly into the
projections of the shaving head holder. Turn the ring clockwise
until your hear a click to indicate that the ring is fixed (Fig. 65).
Note: Hold the shaving head holder in your hand when you
reinsert the shaving heads and reattach the retaining rings
(Fig. 66). Do not place the shaving head holder on a surface
when you do this, as this may cause damage.
7 Attach the shaving head holder to the bottom part of the shaving
unit ('click') (Fig. 54).
8 To reset the replacement reminder, press and hold the on/off button
for approx. 7 seconds (Fig. 67). Wait until you hear two beeps.
Replacing the cleansing brush attachment
The brush head should be replaced every 3 months or earlier if the
brush hairs are deformed or damaged (Fig. 57).
Ordering accessories
To buy accessories or spare parts, visit www.shop.philips.com/
service or go to your Philips dealer. You can also contact the Philips
Consumer Care Centre in your country (see the worldwide guarantee
leaflet for contact details).
The following accessories and spare parts are available:
- SH90 Philips shaving heads
- HQ110 Philips shaving head cleaning spray
- RQ111 Philips beard styler attachment
- RQ585 Philips cleansing brush attachment
- RQ560/RQ563 Philips cleansing brush heads
- JC301/JC302/JC303/JC304/JC305 cleaning cartridge
- HQ8505 supply unit
Note: The availability of the accessories may differ by country.
25
English