Philips S91 series Manual page 18

18
English
Using the trimmer attachment
You can use the trimmer attachment to groom your sideburns and
moustache.
1 Attach the attachment to the appliance ('click') (Fig. 24).
2 Switch on the appliance.
The display lights up for a few seconds.
3 Hold the trimmer attachment perpendicular to the skin and move
the appliance downwards while you exert gentle pressure (Fig. 25).
4 Clean the attachment after use (see 'Cleaning and maintenance').
Using the beard styler attachment with comb
You can use the beard styler attachment with the comb attached
to style your beard at one fixed setting, but also at different length
settings. You can also use it to pre-trim any long hairs before shaving
for a more comfortable shave.
The length settings on the beard styler attachment correspond to the
remaining hair length after cutting and range from 1 to 5mm.
1 Attach the attachment to the appliance ('click') (Fig. 26).
2 Slide the comb straight into the guiding grooves on both sides of
the beard styler attachment ('click') (Fig. 27).
3 Press the length selector and then push it to the left or right to
select the desired hair length setting (Fig. 28).
4 Switch on the appliance.
5 Move the appliance upwards while you exert gentle pressure. Make
sure the front of the comb is in full contact with the skin (Fig. 29).
6 Clean the attachment after use (see 'Cleaning and maintenance').
Using the beard styler attachment without comb
You can use the beard styler attachment without the comb to contour
your beard, moustache, sideburns or neckline to a length of 0.5mm.
1 Pull the comb off the beard styler attachment.
Note: Grab the comb in the center to pull it off the beard styler
attachment. Do not pull at the sides of the comb (Fig. 30).