Philips S91 series Manual page 22

22
English
1 Press the button on the side of the SmartClean system (1) and lift
the top part of the SmartClean system (2) (Fig. 42).
2 Remove the cleaning cartridge from the SmartClean system and
pour out any remaining cleaning fluid (Fig. 50).
You can simply pour the cleaning fluid down the sink.
3 Throw away the empty cleaning cartridge.
4 Unpack the new cleaning cartridge and pull off the seal (Fig. 43).
5 Place the cleaning cartridge in the SmartClean system (Fig. 44).
6 Push the top part of the SmartClean system back down ('click')
(Fig. 45).
Cleaning the shaver under the tap
Clean the shaver after every shave for optimal performance.
Caution: Be careful with hot water. Always check if the water is not
too hot, to prevent burning your hands.
Never dry the shaving unit with a towel or tissue, as this may
damage the shaving heads.
1 Switch on the shaver.
2 Rinse the shaving unit under a warm tap (Fig. 22).
3 Switch off the shaver. Pull the shaving head holder off the bottom
part of the shaving unit (Fig. 51).
4 Rinse the hair chamber under the tap (Fig. 52).
5 Rinse the shaving head holder under a warm tap (Fig. 53).
6 Carefully shake off excess water and let the shaving head holder dry.
7 Attach the shaving head holder to the bottom part of the shaving
unit ('click') (Fig. 54).
Cleaning the click-on attachments
Note: Never dry the trimmer or beard styler attachments with a towel
or tissue, as this may damage the trimming teeth.