Avaya 9608 Installation And Maintenance Manual page 41

1. When you select 802.1X from the Craft Local Procedure Screen, the following text
2. Select (highlight) the line you want to change, then press Change.
3. Depending on which line you selected to change, the following text displays:
4. To change the setting, press the Right (or Left) navigation arrow to cycle through
5. Press/touch Save to store the new setting and redisplay the Craft Local Procedure
H.323 Installation & Maintenance Guide R6.1
displays:
Supplicant:
Pass-thru:
where the Supplicant line is the text string associated with the current system value
of DOTIXSTAT (802.1X Supplicant Mode operation control), defined as:
• "Disabled" if DOT1XSTAT = 0
• "Unicast-only" if DOT1XSTAT = 1
• "Unicast/multicast" if DOT1XSTAT = 2
and the Pass-thru line is a text string associated with the current system value
of DOT1X (802.1X Supplicant Mode)
• "Enabled mode" if DOT1X = 0
• "Enabled w/Logoff" if DOT1X = 1
• "Disabled" if DOT1X = 2
Current setting:
New Setting:
where, if you selected the Supplicant line, the setting is the text string associated
with the current system value of DOTIXSTAT, or if you selected the Pass-thru line,
the setting is the text string associated with the current system value of DOTIX.
the applicable settings.
Depending on the current value, the next sequential text string is selected and
displayed as the New setting. For example when changing the Pass-thru mode, if
the current value is Pass-thru mode, pressing the Choice Selector displays P-t w/
Logoff. If the current setting is disabled, pressing the Choice Selector changes the
new setting to Pass-thru mode.
screen.
Setting the 802.1X Operational Mode
May 2011 41