IBM pSeries 690 User Manual page 59

An example of this menu follows:
LED Control Menu
1. Set/Reset Identify LED state
2. Clear System Attention Indicator
98. Return to Previous Menu
Enter LED index
0 >
The processor subsystem disturbance or system attention LED is located on the operator panel in the
media drawer. The I/O drawer fault/identify LED is located on the front of each I/O subsystem.
If option 1 is selected, a list of location codes of the I/O subsystems and the CEC drawer displays. The
screen will be similar to the following:
1. U1.9-P1
2. U1.9-P2
3. U1.5-P1
4. U1.5-P2
5. U1.1-P1
6. U1.1-P2
7. U2.1-P1
8. U2.1-P2
9. U2.5-P1
10. U2.5-P2
Enter number corresponding to the location code, or
press Return to continue, or 'x' to return to the menu.
0>4
If one of the devices is selected using the index number, the present state of its LED will be displayed,
and you are given the option to toggle it, as shown in the following screen. The final state of the LED
will then be displayed, whether or not it was changed.
U1.5-P2 is currently in the OFF state
Select from the following (1=IDENTIFY ON, 2=IDENTIFY OFF)
0>2
Please wait...
U1.5-P2 is currently in the OFF state
(Press Return to continue)
Option 2, Clear System Attention Indicator, will clear the attention indicator on the operator panel in
the media drawer.
v MCM/L3 Interposer Plug Count Menu
Attention: Do not power on the system when in this menu. Fully exit this menu before powering on
the system.
This menu tracks the number of times that the MCMs and L3 cache modules have been plugged into
the system backplane.
Chapter 4. Using the Service Processor
43