IBM pSeries 690 User Manual page 57

Please wait....
Fru type = 00f6 BPC-RH
Cage id = ff BPA
Port = A
Fru id = 80 BPC
Location Code = U1.35-P1-X4
Code level = 0000255e
Status = 01 Successfully collected
Fru type = 0048 DCA-RHP
Cage id = 00 CEC Cage
Fru id = 90 DCA 1
Location Code = U1.18-P1-V1
Code level = 00000027
Status = 01 Successfully collected
Fru type = 0050 MDA-X
Cage id = 00 CEC Cage
Fru id = 98 MDA 1
Location Code = U1.18-X1
Code level = 00000007
Status = 01 Successfully collected
Fru type = 0047 DCA-BC
Cage id = 01 I/O Drawer 1
Fru id = 90 DCA 1
Location Code = U1.9-V1
Code level = 0000fb23
Status = 01 Successfully collected
Fru type = 0054 MDA-BC
Cage id = 01 I/O Drawer 1
Fru id = 98 MDA 1
Location Code = U1.9-V1
Code level = 00000005
Status = 01 Successfully collected
v Power Subsystem Code Update via the Power Control Network
If this option is enabled (the default), the power subsystem's code update will be controlled by the
system power control network code. If this option is disabled, the power subsystem's code update will
be controlled by the HMC. Enabling the update by the SPCN locks out the update from the HMC and
vise-versa.
This option should only be disabled if a High Performance Switch (machine type 7045-SW4) was
installed at the factory, or is added to the frame or connected to the system as an MES. If the High
Performance Switch is removed from the system, or it is detached from the system, this option should
be reenabled.
v Start Power Subsystem Code Update
Selecting this option forces the service processor to initiate a firmware update for all of the power
subsystem codes; this includes the SPCN code.
As the various types of firmware are updated, the service processor will report the progress of the
update on the screen (as long as the system remains in standby) until the update is complete. An
example of this output follows.
Chapter 4. Using the Service Processor
41