Rear Master Cylinder/Brake Pedal Disassembly - Honda VTR1000F Service Manual

HYDRAULIC BRAKE
REAR MASTER CYLINDER/BRAKE PEDAL
15-12
CAUTION:
• Avoid spilling fluid
on
painted, plastic or rubber
parts. Place
a
rag over these parts whenever the
system is serviced .
• When removing the oil bolt, cover the end of the
hose
to
prevent contamination.
DISASSEMBLY
Drain the brake fluid from the rear brake hydraulic
system (page 15-3).
Disconnect the brake hose from the master cylinder
by removing the oil bolt and sealing washers.
Loosen the master cylinder mounting bolts.
Support the motorcycle securely with a hoist or
equivalent.
Remove the swingarm pivot caps.
Remove the lower muffler mounting bolt and wash-
er.
Remove the swingarm pivot nut.
Remove the socket bolt, collar, swingarm pivot bolt
and right driver footpeg bracket.
Remove the master cylinder mounting bolts.
Remove the snap ring, washer and brake pedal
from the pedal pivot shaft.
Remove the cotter pin from the joint pin.
Remove the joint pin and master cylinder from the
brake pedal.
Remove the snap ring and reservoir hose joint from
the master cylinder.
Remove the O-ring.
OIL BOLT
MOUNTING BOLTS
r.»
MUFFLER MOUNTING BOLT
PIVOT BOLT
1
SOCKET BOLT