Printer Administration Using The Snmp Manager (Hp Openview) - Oki PAGE 12i User Manual

Type "4" and press the Enter key. Then the current settings are
displayed.
2. Change the settings.
OkiPage>set protocol [RET]
<<Protocol setting>>
<Select Protocol>
TCP/IP=1 NetWare=2 EtherTalk=3 EXIT=0 : 3 [RET]
Will you use EtherTalk ?
Enter "n" if you will not use EtherTalk.
AppleTalk Zone Name(1-32char) : * [RET]
AppleTalk Printer name(1-32char) : OKIPAGE 12i
Are you re-setting ? (y/n) : n [RET]
OkiPage> logout (or exit, quit)[RET]
Enter an appropriate command, without logging out, if you want to
set other protocols, too.
4.1.4 Printer administration using the SNMP Manager (HP
OpenView)
OKIPAGE 12i and this network card support Management Information
Base (MIB, hereafter).
MIB is information that is sent/received between the managing host and
the devices that are managed, with SNMP protocol, for the network man-
agement, defined in RFC1213 (MIB II).
The structure of the MIB is expressed by Abstract Syntax Notation One
(ASN.1), and normally the results of compilation to the C-Language source
using the ASN.1 compiler are used in a management software and a device
to which it is incorporated.
For the OKIPAGE 12i , please use an ASN.1 file comes with this Network
card.
For the OKIPAGE 12i, please use a compiler comes with the SNMP
Manager.
Of the MIBs defined by various RFCs, OKIPAGE 12i supports Private MIB
only.
4. ADMINISTRATING PRINTERS IN NETWORK
(y/n) : y [RET]
51