Oki OKILAN 6200E User Manual page 56

Trap Destination
• NetWare Protocol - Enter the network number
and hardware address, respectively, to which traps
will be sent. To broadcast traps to all addresses on
all networks, enter FFFFFFFF (8 characters) in the
first field and FFFFFFFFFFFF (12 characters) in
the second field. To broadcast traps to all
addresses on a specific network, enter the network
number in the first field and then FFFFFFFFFFFF
(12 characters) in the second field.
• TCP/IP Protocol - Enter the IP address to which
traps will be sent. The IP address must follow the
format XXX.XXX.XXX.XXX, where each XXX is a
number from 0 to 255. To broadcast traps to all
hosts on the local subnet, enter 255.255.255.255.
Ports to Trap
Select the output ports on which you wish traps to be
active.
Printer Traps
Select the printer traps to be activated. The following
printer conditions may cause a printer trap to occur if
the OKI printer model supports the features:
• On-line
• Off-line
• No Printer Attached
• Paper Out
• Toner Low
• Paper Jam
Novell NetWare
OkiLAN 6200e Plus User's Guide
56