Canon imageprograf IPF785 User Manual page 423

iPF785
Inter- TCP/IP IPv4
face
Setup
IPv6
Ether- Auto Detect
net
Driver
Comm.Mode
Ethernet Type
Spanning Tree
MAC Address
Interface Print
Return Defaults
System Sleep Timer
Setup
Shut Down Timer
Buzzer
Contrast Adj.
Date & Date
Time
Time
Date Format
User's Guide
Setting Item
Proto-
BOOTP
col
RARP
IPv4 IP Address
Settings
Subnet Mask
Default G/W
DNS DNS Dync update
Settings
Pri. DNS SrvAddr
Sec. DNS SrvAddr
DNS Host Name
DNS Domain Name
IPv6 Support
IPv6 StlessAddrs
DHCPv6
DNS DNS
Settings Dync
update
Pri. DNS SrvAddr
Sec. DNS SrvAddr
DNS Host Name
DNS Domain Name
Description, Instructions
Specify the protocol used to configure the IP address au-
tomatically.
Specify the printer network information when using a stat-
ic IP address.
Enter the IP address assigned to the printer, as well as
the network subnet mask and default gateway.
The value that was automatically configured is displayed if
you have set IPv4 Mode to Automatic.
Specify whether DNS server registration is updated auto-
matically.
Specify the DNS server address.
Specify the DNS host name.
Specify the DNS domain name.
Specify whether to connect via IPv6.
Specify whether a IPv6 stateless address is used.
Specify whether DHCPv6 settings are used.
Statefull Specify whether DNS server registration is updated auto-
Addr matically.
State-
less
Addr
Specify the DNS server address.
Specify the DNS host name.
Specify the DNS domain name.
Specify the communication method. To apply your
changes, choose Register Setting.
Choose On for automatic configuration of the LAN com-
munication protocol. Choose Off to use settings values of
Comm.Mode and Ethernet Type.
Choose the LAN communication method.
Choose the LAN transfer rate.
Choose whether spanning-tree packets are supported
over the LAN.
Indicates the MAC address.
Print interface settings information.
Choose OK to restore Interface Setup settings to the de-
fault values.
Specify the period before the printer enters sleep mode.
Sets the time until the printer turns off automatically. If no
operations are performed on the printer for the duration of
the time set in Shut Down Timer after entering Sleep
mode, the printer automatically turns off.
Choose On for the buzzer to sound once for warnings and
three times for errors.
Adjust the Display Screen contrast level.
Set the current date.
Set the current time. Available only if the Date setting is
specified.
Specify the date format.
Menu Settings
423