Color Menu; System Configuration Menu - Oki C810 User Manual

COLOR MENU

The printer automatically adjusts color balance and density at appropriate intervals,
optimising the printed output for bright white paper viewed in natural daylight conditions.
The items on this menu provide a means of changing the default settings for special or
particularly difficult print jobs. Settings revert to their default values when the next print
job is complete.
ITEM
DENSITY CONTROL
ADJUST DENSITY
AJST REGSTRATION
C REG FINE ADJ
M REG FINE ADJ
Y REG FINE ADJ
S
YSTEM CONFIGURATION MENU
This menu adjusts general printer settings to suit the way you prefer to work.
ITEMS
POW SAVE DELAY
CLRABLE WARNING
MANUAL TIMEOUT
WAIT TIMEOUT
TONER LOW CONTINUE
JAM RECOVERY
ERROR REPORT
SETTINGS EXPLANATION
AUTO Selecting this will permit automatic adjustment of the
color density.
MANUAL
EXECUTE Image density will be automatically adjusted at power
on, when a new image drum or toner cartridge is
installed, and at intervals of 100, 300 and 500 drum
counts. If a 500 drum count interval occurs during a
print job it will occur at the end of that job, and will
take up to 55 seconds.
EXECUTE Performs automatic color registration adjustment.
Normally this is done on power on and when the top
cover is opened and then closed. This process
accurately aligns the cyan, magenta and yellow images
to the black image.
-3~0~+3 Performs fine adjustment of image timing in relation to
the black image component.
-3~0~+3
-3~0~+3
SETTINGS EXPLANATION
5 Adjusts the idling time before the printer automatically
switches into power saving mode. In this mode power
15
30 consumption is reduced to a low level required to just
60 keep the printer operating and ready to receive data.
240 When a job is sent the printer will require a warm-up
time of up to 1 minute before printing can begin.
ONLINE When ONLINE, non-critical warnings, such as requests
JOB for a different paper size, can be cleared by pressing
the
cleared when the print job resumes.
OFF Specifies how many seconds the printer will wait for
30 paper to be fed before cancelling the job.
60
OFF~90~300 Specifies how many seconds the printer will wait when
received data pauses before forcing a page eject. In
PostScript Emulation mode the job will be cancelled if
timeout occurs.
CONTINUE Specifies whether the printer should continue printing
STOP even after a low toner condition is detected.
ON Specifies whether the printer should perform jam
OFF recovery after a paper jam has occurred. If ON, the
printer will attempt to print again any pages lost due to
a paper jam once the jam has been cleared.
ON Sets whether an error report is printed when an
OFF internal fault occurs.
Menu functions - C810 > 26
ON LINE
button. When set to JOB, they are