Calibration - Oki C810 User Manual

ITEM
Change New
Password Password
Verify
password
Settings Reset
Settings
Save
Settings
C
ALIBRATION
ITEM
Auto Density
Mode
Adjust Density
Adjust
Registration
Print Tuning
Pattern
Cyan/Magenta/ Highlight
Yellow/Black
Tuning
Mid-Tone
Dark
Cyan/Magenta/
Yellow/Black
Darkness
SETTINGS EXPLANATION
xxxxxxxxxxxxxx Sets a new password to enter Admin Setup menu
From 6 to 12 alpha/numeric digits can be entered.
xxxxxxxxxxxxxx Forces the User to input the new password to enter Admin
Setup.
From 6 to 12 alpha/numeric digits can be entered.
Execute Resets EEPROM of CU. Resets User menu to the factory
default.
If Execute is selected, exits from the menu.
Execute Saves menus currently set. With this function, the menus
with which operation was last performed are saved, and
overwrites with them menus that were previously saved.
When the Enter button is pressed, the following
confirmation message appears.
Are You Sure? Yes/No
When No is selected, the preceding menus are restored.
When Yes is selected, the current menu settings are
saved and this menu is exited.
SETTINGS EXPLANATION
On/Off Enables/disables automatic density adjustment.
Execute If Execute is selected, the printer will immediately
adjust density and reflect it in TRC compensation.
This adjustment must be executed when the
printer is idling. It can become invalid if executed
in any other state.
Execute When this menu is selected, the printer performs
AutoAdjust Registration.
This adjustment must be executed when the
printer is idling.
Execute Prints the pattern for the user to adjust TRC.
Ordinarily, this function is not needed because TRC is
automatically adjusted to the recommended levels
through density adjustment and TRC compensation.
Adjustment results will be reflected as offset values
(addition) to the corrections through the Adjust
Density/TRC Compensation function.
-3,-2,-1, Adjusts HIGHLIGHT (light area) of the TRC.
0,+1,+2,+3,
+ = Darker
- = Lighter
-3,-2,-1, Adjusts MID-TONE area of the TRC.
0,+1,+2,+3,
+ = Darker
- = Lighter
-3,-2,-1, Adjusts DARK area of the TRC.
0,+1,+2,+3,
+ = Darker
- = Lighter
-3,-2,-1, Adjusts the engine density.
0,+1,+2,+3,
The Darkness settings for each of CMYK will be
reflected as offset values (addition) to the corrections
through the Adjust Density/TRC Compensation
function.
Menu functions - C830 > 52