Epson L800 Service Manual page 56

L800/L801
3. Disengage the two hooks (1) (2) that secure the ASF Unit from the Main
Frame.
4. Remove the Combination Gear (10,15.2), then remove the ASF Unit while
releasing the edge of the Change Lever from the hole of the Main Frame.
[Rear Side]
Combination
Gear
Figure 1-102. Removing the ASF Unit
Disassembly/Reassembly
Downloaded from www.Manualslib.com
Hook (1)
Change Lever
Hook (2)
Removal Direction
ASF Unit
manuals search engine
̈
Lubrication is required. See the page given below for the
lubrication information.
Lubrication of ASF Unit (p.94)
̈
When installing the ASF Unit, make sure that the Combination
Gear, tip of the Change Lever and the two hooks are securely
attached. Also make sure that there is appropriate space at
both the left and right of the Change Lever.
̈
Tighten the screws in the order given in
̈
Install the LD Roller following the procedure below. Make
sure to apply grease referring to the page given below.
Lubrication of the ASF Unit (p.94)
1. Install the LD Roller aligning the arrow on the LD Roller with
the arrow on the blade of the shaft. Make sure the LD Roller is
securely attached without gap or misalignment.
Align the arrows
Figure 1-103. Reinstalling the LD Roller
Whenever the ASF Unit is removed or replaced, the required
A D J U S T M E N T
R E Q U I R E D
adjustments must be carried out.
Refer to "2.1.2 Required Adjustments" (p.74)
ASF Unit
Revision A
Fig.1-101 (p.54).
LD Roller
ASF Unit
LD Roller Shaft
Blade
Confidential
55