L800/L801
2.
Release the Waste Ink Tube from the groove
3.
Release the CR Motor Cable from the two ribs
CR Motor Cable
Waste Ink Tube
Waste Ink Tube
Figure 1-44. Removing the Printer Mechanism (1)
4.
Disconnect the connector of the CDR Guide Sensor.
CDR Guide Sensor Cable
Figure 1-45. Removing the Printer Mechanism (2)
Disassembly/Reassembly
Downloaded from
www.Manualslib.com
of the Waste Ink Tray.
of the Waste Ink Tray.
Waste Ink Tray
CDR Guide Sensor
Opening
Removing the Printer Mechanism
manuals search engine
5.
Remove the five screws and remove the Printer Mechanism.
Screw
: C.B.P.(P2) M3x8 (tightening torque:5-7 kgf.cm)
(The numbers shown in the figure indicate the order of tightening the screws.)
2
Positioning Hole and
Guide Pin
Figure 1-46. Removing the Printer Mechanism (3)
Revision A
4
5
3
1
36
Confidential