Epson L800 Service Manual page 40

L800/L801
7. Remove the three screws and remove the Printhead.
Screw : C.B.P. M2.6x8 (tightening torque: 3-5 kgf.cm)
(The numbers shown in the figure indicate the order of tightening the screws.)
3
Figure 1-53. Removing the Printhead (1)
8. Remove the two Head FFCs from the connectors on the back, and remove the
Printhead.
Head FFC
Connectors
Figure 1-54. Removing the Printhead (2)
Disassembly/Reassembly
Downloaded from www.Manualslib.com
2
Printhead
1
Printhead
manuals search engine
Tighten the screws in the order given in Fig.1-53.
Whenever the Printhead is removed/replaced, the required
A D J U S T M E N T
R E Q U I R E D
adjustments must be carried out.
Refer to "2.1.2 Required Adjustments" (p.74)
Printhead
Revision A
39
Confidential