Epson L800 Service Manual page 14

L800/L801
5. When the ink stops flowing from the tube, close the choke valve, and
then connect the Ink Supply Tube back to the joint.
6. Disconnect the Ink Supply Tube of the same color connected to the
opposite side of the joint.
7. Connect the tube from the injector.
8. Open the choke valve again, and suck up the remaining ink in the Ink
Supply Tank into the injector.
9. Disconnect the tube from the injector, and connect the Ink Supply Tube
of the same color back to the joint.
Tube
Figure 1-6. Discharging Ink (2)
10. Repeat Step 3 to Step 10 for all ink tanks to discharge all ink in the Ink
Supply Tank.
Disassembly/Reassembly
Downloaded from www.Manualslib.com
Joint
manuals search engine
̈
C H E C K
P O I N T
̈
Injector
(tip of 3.2 mm)
Overview
It is recommended that the ink in the Ink Supply Tank should
be discharged completely before proceeding to disassembling/
reassembling.
After all the reassembling work is complete, the discharged ink
of each color should be refilled back to the Ink Supply Tank
before performing the adjustment. Confirm the colors
indicated on the film of the Ink Supply Tank so as not to
mistake them, and make sure to refill each ink back to the
correct tank from the corresponding ink supply hole.
Ink supply hole
Revision A
Ink Supply Tank Assy
13
Confidential