Using The Cable Clamps (Hot-Plug Psu); Notes On Connecting/Disconnecting Cables - Fujitsu PRIMERGY RX2510 M2 Operating Manual

5.4.1

Using the cable clamps (hot-plug PSU)

You can secure the power cord using a cable clamp to ensure that the insulated
connector cannot be disconnected from the server accidentally. The cable clamp is
included in the accessories pack that is delivered together with the server.
Figure 4: Using cable clamps
Ê Pull the cable clamp up (1).
Ê Thread the power cord through the cable clamp (2).
Ê Press the cable clamp down until it engages to secure the cable (3).
5.5

Notes on connecting/disconnecting cables

V
CAUTION!
Always read the documentation supplied with the device you wish to
connect.
Never connect, or disconnect cables during a thunderstorm.
Never pull on a cable when disconnecting it. Always take hold of the
cable by the plug.
Follow the sequence described below to connect or disconnect external
devices to or from the server:
Be sure to wait for 10 seconds or more after shutdown before turning the
server on.
RX2510 M2
Operating Manual
Hardware installation
47