Tunturi 14PTUB2000 User Manual page 8

Console, Seat, Pedals And Main
Housing Covers Assembly
1. Insert the Computer Cable (29) and
two Hand pulse cables (26) into
the connectors in the back of the
Console (34). Install the Console (34)
onto the Upright tube at the bottom
with two M5x12mm Phillips Head
Screws (58).Then fasten the Console
(34) with the Fixing Plate (12) onto
the Upright tube on the top with two
M5x12mm Phillips Head Screws (58).
2. Install the Front Foot Cover (40) and
the Rear Foot Cover (41) onto the
Main Frame (1) with four M5x12mm Main Frame (1) with four M5x12mm
Phillips Head Screws (58). Phillips Head Screws (58).
3. Install the Pedals (45 L, 46R) Install the Pedals (45 L, 46R)
onto the Crank arms (16L, 16R). onto the Crank arms (16L, 16R).
Remember that the left pedal has a Remember that the left pedal has a
reverse thread and will be screwed reverse thread and will be screwed
into the crank in the opposite rotation into the crank in the opposite rotation
from normal threads. from normal threads.
8
Step 4:
There is an "L" stamped into the end
of the threaded post of the left pedal
and an "R" in the right. Make sure to
tighten the pedals as much as you
possibly can. It may be necessary
to re-tighten the pedals if you feel a
thumping during pedaling the bike. A
noise or feeling such as a thumping
or clicking is usually caused by the
pedals being too loose.
4. Install the Seat slide tube (7) onto the
track on top of the seat tube with the
seat post facing forward. Install the
seat (19) onto the seat post.
5. Install the Bottle Holder (116) onto
the Upright tube with two M5x12mm
Phillips Head Screws (58)..
Phillips Head Screws (58)..