Connection Instructions; Visiting The Ip Camera - Aztech WIPC409HD-E User Manual

User Manual

Connection Instructions

Before visiting the IP Camera, you must first connect it to the Network. Plug it to
a power outlet, and check if the light of the LAN port is normal to make sure all
of the communication links are functioning properly. The connection method
can be seen on the previous page. In addition, ensure that the following items
below are satisfied:
1. IP Camera-1 and IP Camera-2 are connected separately to 2 different
LANs.
2. And these 2 LANs are already connected to the Internet. In order to get the
LANs connected to the Internet, ensure that the router used in the network
has an active internet connection.
3. PC-3 is connected to the Internet.

Visiting the IP Camera

To visit the IP Camera, you must first configure some of your IP Camera's IP
settings.
1. The PC and IP Camera are in the same LAN. If you want to use this PC to visit
the IP Camera, you need to make sure that each device's IP address
belongs to the same segment. Otherwise you may have to reset the IP
Camera's IP address.
For example, if the IP Camera-1's IP address in the image above is
192.168.1.139 (at the segment of 192.168.1.x), while the PC-1's IP address is
192.168.0.175 (at the segment of 192.168.0.x), you will not be able to visit the
IP Camera through PC-1. You must first change the IP Camera-1's IP address
to 192.168.0.139 (or any IP address within the 192.168.0.1 to 192.168.0.254
except 192.168.0.175).
2.
The PC and IP Camera are in different LANs, but they are all connected to
Internet. For the IP Camera-1 and PC-2, if you want to visit IP Camera-1
through PC-2, you must first ensure the following:

Ensure that you can visit IP Camera-1 through PC-1 and then do port
forwarding of the IP Camera on Router-1.

The PC-2's visit application could be sent through router-1 to IP
Camera-1. Normally, PC-2 could only send the information to router-1.
However, if you do not configure the port forwarding settings of the IP
Camera-1 on router-1, PC-2 would not be able to visit IP Camera-1.
9