Wiring Diagram; Bgd36Cfg / Gd36M Light Switch - Napoleon BGD36CFNTR Installation And Operating Instructions Manual

11.0

WIRING DIAGRAM

DO NOT USE THIS APPLIANCE IF ANY PART HAS BEEN UNDER WATER. CALL A QUALIFIED
SERVICE TECHNICIAN IMMEDIATELY TO HAVE THE APPLIANCE INSPECTED FOR DAMAGE TO THE
RISK OF ELECTRICAL SHOCK OR EXPLOSION. DO NOT WIRE 110V TO THE VALVE OR TO THE
APPLIANCE WALL SWITCH. INCORRECT WIRING WILL DAMAGE CONTROLS.
ALL WIRING SHOULD BE DONE BY A QUALIFIED ELECTRICIAN AND SHALL BE IN COMPLIANCE
WITH LOCAL CODES. IN THE ABSENCE OF LOCAL CODES, USE THE CURRENT CSA22.1 CANADIAN
ELECTRIC CODE IN CANADA OR THE CURRENT NATIONAL ELECTRIC CODE ANSI/NFPA NO. 70 IN
ALWAYS LIGHT THE PILOT WHETHER FOR THE FIRST TIME OR IF THE GAS SUPPLY HAS RAN OUT,

11.1 BGD36CFG / GD36M LIGHT SWITCH

A wall switch must be installed in a convenient location to operate the lights. A 20' length of 18 gauge wire is
connected to the lights for the wall switch, however, if a greater length is required, route 2-strand (solid core) wire
complete with two 1/4" female quick connects through the electrical hole located at the bottom left side of the ap-
pliance and connect to the lights as shown.
AC Adaptor
WARNING
!
ELECTRICAL CIRCUIT.
THE UNITED STATES.
WITH THE GLASS DOOR OPENED OR REMOVED.
LED Light Bar
69.2
To Remote Wall Switch
(20' Remote Switch Wire Supplied)
69.2
47
EN
W415-1132 / C / 08.20.13