Rimage Everest Printer
Cleaning the Everest printer
Clean the printhead
Before you begin:
Power off the printer
1. Access the printhead.
a. Press the two cover latches to release the side
cover.
b. Lower the side cover.
c. Open latch 1.
d. Remove the print ribbon carrier.
2. Clean the printhead.
a. Apply isopropyl alcohol to the sponge swab.
b. Use the sponge swab to wipe across the
printhead.
c. Repeat as needed until the printhead is clean
of dust and debris.
d. Use the sponge swab to remove any waxy
buildup from the bar below the printhead.
Important! Wipe the printhead from one end to
the other. Do not stop wiping in the middle of
the printhead.
Important! Do not scratch the printhead. The
highlighted area in the picture shows the area
to clean.
3. Prepare the printer for use.
a. Install the print ribbon carrier.
b. Close all latches.
c. Close the side cover.
d. Power on the printer. The printer is ready.
22
Cover Latches
Side Cover
Latch 1
Printhead
Wipe Direction
110632_H