Rimage everest User Manual page 25

3. Install the new print ribbon.
a. Remove the new ribbon from the packaging.
b. Install the supply roll end of the print ribbon on the top of the carrier.
c. Insert the large shaft in the large opening and snap in the small shaft.
Note: The ribbon must come over the tacky roller.
Large Opening
Small Shaft
Tacky Roller
Snap Into Place
Supply Roll
d. Wrap the ribbon around the guide rollers.
e. Install the take up roll.
f. Rotate the take up roll so the ribbon is
aligned and without creases.
Tip: You may need to lift the ribbon up from
the tacky roller to straighten it.
Note: If you installed a monocolor ribbon,
advance the ribbon so the ink portion o
ribbon is advanced to the take up roll.
4. Reassemble the printer.
a. Slide the carrie
b. Close latch 1.
c. Close the side cover.
5. Power on the printer. The printer is ready.
110632_H
Guide Roller
Pull Handle
Supply Roll
Take Up Roll
r into the printer.
Maintain the Everest printer
f the
s
19