Meridian Communications Adapter - Nortel M2016S Quick Reference Manual

Meridian Communications Adapter

Meridian Communications Adapter
AT dialing commands
AT dialing commands are similar to those used to make data calls using a Hayes
Smartmodem*. AT dialing is not case sensitive. Commands not found here do not
apply to using the Meridian Communications Adapter, and are not supported.
To user AT dialing:
ATA
ATDnnn
A/
ATO
ATDPnnnn
ATF3
ATF4
ATF5
ATH0
ATHP
ATIn
19
CTRL - z
AT<CR>
- Answer (answer incoming data call)
- Dial (n= 0 - 9, numbers to be dialed)
- Repeat last command (no <CR> needed)
- On-line (hit three Escape characters rapidly to
- Voice Call (n= 0 - 9, * and #, numbers to dial)
- Handsfree Mute (toggle between mute and
- Hold (put Voice Call on hold)
- Select (take Voice Call off hold)
- Hang up Data Call
- Hang up Voice Call
- Product ID code (n= 0, 1, 4; if n= 0 then send
go off line)
normal)
Smartmodem ID; if n= 1 then send result code
"206;" if n= 4 then send result codes
"a037800C004420" and "b100000000")