Connecting The Supplied Power Cable - NEC NP2000 User Manual

Connecting the Supplied Power Cable

Connect the supplied power cable to the projector.
First connect the supplied power cable's three-pin plug to the AC IN of the projector, and then connect the other plug
of the supplied power cable in the wall outlet.
To wall outlet
Make sure that the prongs are fully
inserted into both the AC IN and the
wall outlet.
About Direct Power Off
The projector has a feature called "Direct Power Off". This feature allows the projector to be turned off (even when
projecting an image) using a power strip equipped with a switch and a breaker.
NOTE: Before using Direct Power Off, be sure to allow at least 20 minutes immediately after turning on the projector and starting to
display an image.
CAUTION:
Do not try to touch the ventilation outlet on the left front (when seen from the front) as it can become heated white
the projector is turned on and immediately after the projector is turned off.
CAUTION:
Do not unplug the power cable from the wall outlet or projector when the project is powered on. Doing so can cause
damage to the AC IN connector of the projector and (or) the prong plug of the power cable.
TIP: To turn off the AC power supply when the projector is powered on, use a power strip equipped with a switch and a breaker.
TIP: The projector can be unplugged during its cool down period after it is turned off.
2. Installation and Connections
23