NEC NP2000 User Manual page 875

3. Insert a new lamp housing until the lamp housing is plugged into the socket.
CAUTION
Do not use a lamp other than the NEC replacement lamp NP01LP.
Order this from your NEC dealer.
Secure it in place with the two screws.
Be sure to tighten the screws.
4. Reattach the lamp cover.
Slip the lamp cover back until it snaps into place.
5. Connect the supplied power cable, turn on the Main Power switch and turn on the projector.
6. Finally, select the menu → [Reset] → [Clear Lamp Hours] to reset the lamp life remaining and lamp
usage hours.
NOTE: When the lamp exceeds 2100 hours (up to 3100 hours in Eco mode) of service, the projector cannot turn on and the menu
is not displayed.
If this happens, press the HELP button on the remote control for 10 seconds to reset the lamp clock back to zero.
When the lamp time clock is reset to zero, the LAMP indicator goes out.
1
2
E-9