Auto Tuning - Sangean DPR-16 Operating Instruction

Auto tuning

. Carefully extend the telescopic aerial and press the Standby
button to switch on your radio.
2. Press the Band button as needed to select FM radio mode.
3. Press the Tuning Control Rotary will scan up the FM band from
the currently displayed frequency and stop scanning when it finds
a station of sufficient strength. The display will show the frequency
of the signal which has been found. If RDS information is available,
after a few seconds the display will show the radio station name.
If you only hear hiss or interference, simply press the Tuning
Control Rotary to scan further.
4. To find more FM stations press the Tuning Control Rotary to repeat
the scan operation. When the end of the waveband is reached,
your radio will recommence tuning from the opposite end of the
waveband. Use the Volume buttons to adjust the sound level or
press the Mute button to mute the sound as needed.
23