Table of Contents
Advertisement
V.34 Modem Adapter Module Supplement
Completing Software Configuration
Once you have successfully installed the V.34 Modem adapter module, complete
the following software configuration tasks using instructions found in your BayRS
documentation:
Configuration Task
Modify the configuration file to add the V.34
Modem adapter module and enable default
software services.
When using Bay Command Console (BCC)
commands on a Passport 2430, note that
the name for the V.34 Modem adapter
module is arnv34.
Connect the Passport 2430 to the network.
Configure V.34 modem services.
For the latest information, be sure to review the release notes and documentation
change notice for your version of BayRS software.
Interpreting LEDs
The V.34 modem adapter has four LEDs, located to the right of the connector
(Figure 3-2).
Figure 3-2.
3-2
Telco
V.34 Modem
Complies with FCC Rules Part 68 Reg. Number 4P8USA-30661-MD-E Ringer Equivalence 0.6B
V.34 Modem Adapter Module LEDs
Location of Instructions
Any of the following:
•
Configuring and Managing Routers with
Site Manager
•
Using the Bay Command Console
(BCC)
One of the following:
•
Installing and Operating the Passport
2430 Multiservice Access Switch
•
Configuring Remote Access for AN and
Passport ARN Routers
Configuring Dial Services
TX
RLSD
RX
DTR
ARN0107A
303127-D Rev 00
Advertisement
Table of Contents
