Table of Contents
Advertisement
Completing Software Configuration
Once you have successfully installed the V.34 Modem adapter module, complete
the following software configuration tasks using instructions found in your BayRS
documentation:
Configuration Task
Connect the ARN to the network.
Modify the ARN configuration file to add the
V.34 Modem adapter module and enable
default software services.
When using Bay Command Console
(BCC
that the name for the V.34 Modem adapter
module is arnv34.
Configure V.34 modem services.
For the latest information, be sure to review the release notes and documentation
change notice for your version of BayRS software.
Interpreting LEDs
The V.34 modem adapter module has four LEDs, located to the right of the
connector (Figure 1-2).
Figure 1-2.
303127-D Rev 00
Using the V.34 Modem Adapter Module in a Passport ARN Router
) commands on an ARN router, note
™
Telco
V.34 Modem
Complies with FCC Rules Part 68 Reg. Number 4P8USA-30661-MD-E Ringer Equivalence 0.6B
V.34 Modem Adapter Module LEDs
Location of Instructions
One of the following:
•
Installing and Operating Passport ARN
Routers
•
Configuring Remote Access for AN and
Passport ARN Routers
Any of the following:
•
Configuring and Managing Routers with
Site Manager
•
Using the Bay Command Console
(BCC)
Configuring Dial Services
TX
RLSD
RX
DTR
ARN0107A
1-3
Advertisement
Table of Contents
