Nortel Versalar 5399 Quick Start Manual page 25

Leave cli security off so you can access the RAC from the console.
7.
admin:
Set vcli security.
8.
admin:
Reboot the RAC for the configuration changes to take effect.
9.
admin:
annex#
After the RAC is rebooted, try to log on to the RAC through a telnet
10.
session. If security is working you may go ahead and set cli security using
the following admin command:
admin:
PPP Setup
To set up PPP security, perform the following:
Log on to the RAC as superuser and run
1.
Set PPP security.
2.
admin:
Set PPP security protocol.
3.
admin:
Enable security for terminal dial-in users.
4.
admin:
Set the RAC for PPP callers only.
5.
admin:
admin:
300855-C Rev. 00
set port cli_security n
set annex vcli_security y
quit
boot
set port cli_security y
set port slip_ppp_security y
set port ppp_security_protocol < security protocol > (pap or chap)
set port cli_security y
set port mode ppp
reset port
Quick-Start Guide
.
admin
13