Nortel Versalar 5399 Quick Start Manual page 18

Access switch

Hide thumbs Also See for Nortel Versalar 5399:

Table of Contents

Quick-Start Guide for Nortel Networks 5399 and 8000 Access Switches

Set the Network Addresses

This section uses the IP addresses established in Task 1. To set the network

addresses:

At the ROM monitor prompt, enter

shown in the example. To accept the default shown in brackets, press the

Return key.

Note: For illustration purposes, this example shows a RAC on an Ethernet

network with the IP address 192.9.200.62. The host system address is

192.9.200.55. The router gateway address would be 192.9.200.1 for this subnet

to access other subnets.

monitor::

Enter Internet address::

Enter Subnet mask [255.255.255.0]::

Enter Broadcast address::

Enter preferred Load Host address::

Enter Preferred Dump Host [0.0.0.0]::

Enter Load/Dump Gateway address::

Select type of IP packet encapsulation (ieee802/ethernet)

[<ethernet>]::

Load Broadcast y/n [y]::

After you enter the address path names, enter

address.

After you verify the IP address, set the operating image.

addr

192.9.200.62

192.9.200.255

and respond to the prompts as

addr

192.9.200.55

192.9.200.1

ad -d

to verify the IP

300855-C Rev. 00

Table of Contents

Versalar 8000 8000