Using The Sleep Timer - Denon DHT-M330DV Operating Instructions Manual

14

USING THE SLEEP TIMER

(1) Setting the sleep timer (remote control unit only)
• The included remote control unit can be used to turn the power to the standby mode after a maximum of 120 minutes. (Sleep timer)
• Use this function to automatically switch the power to the standby mode after a specific amount of time (minutes).
Example: To set the power to the standby mode in 50 minutes according to the clock. Be sure to correct the current time setting.
• Operate the remote control unit at the "AMP" position.
Set the remote
2, 3
control selector
switches
Switch1 to DVD
Switch2 to AMP
1 Select and play the desired function.
2 Press the SLEEP button.
• "120" is displayed and the "SLEEP" indicator flashes.
1 2 0
The display switches as follows each time the SLEEP
button is pressed:
120 90 60 50
"SLEEP" indicator off
3 When the "SLEEP" indicator is flashing, press the SLEEP
button again until "50" is displayed.
• "50" is displayed and the "SLEEP" indicator flashes.
5
0
• After 4 seconds, the display returns to as it was before the
sleep timer was set, and the "SLEEP" indicator stops
flashing, remaining lit. (This completes the sleep timer
setting.)
Remote control unit
40 30 20 10
Remote control unit
4 The power is set to the standby mode 50 minutes later.
To turn the sleep timer off, press the SLEEP button repeatedly until
the "SLEEP" indicator turns off. The sleep timer can also be
turned off by press the power button on the main unit or the
remote control unit to turn the entire system's power to the
standby mode.
Remote control unit Main unit
ENGLISH
Remote control unit
53