Hints And Tips; Accessories; Repairs; Environmental Protection - Metabo BSZ 9.6 Operating Instructions Manual

Removing the chuck
10
11
Open the rapid-action keyless chuck.
a Loosen the screw (10)
(NB: left-hand thread).
b Screw off the chuck (1) using an open ended
spanner (11).
Replace the chuck by reversing the above
procedure.
Cleaning
Clean from time to time by holding the tool with
the rapid-action keyless chuck facing vertically
downwards and twist the sleeve as far as it will
go towards "GRIP, ZU", and then turn back fully
in the opposite direction ("AUF, RELEASE").
The dust which has accumulated will fall out of
the chuck.

8 Hints and Tips

Drilling
Use of 2nd gear is recommended (higher
speed).
Switch on impulse mode for drilling into steel,
aluminium or tiles, with no need for preliminary
centre-punching and pilot drilling.
Drill tiles and other brittle materials without
impact.
In the case of deep bores pull the drill bit out of
the bore from time to time in order to remove
the bore dust or shavings.
Driving screws
Use of 1st gear is recommended (low speed),
and with the torque control feature in operation.
When driving screws with deformed heads in
wood, switch on impulse mode (depending on
equipment).
Switch on impulse mode (depending on equip-
ment) to achieve maximum torque when driving
screws.
Tapping threads
Apply a light film of oil to the tap.
Select 1st gear (low speed).
1
Switch on torque control.
Use original Metabo accessories only.
To assist in selecting the correct accessories,
make sure that you take a note of the exact
model of your tool for your dealer.
Any Metabo power tool in need of repair can be
sent to one of the addresses listed in the spare
parts list.
Please attach a description of the fault to the
tool.
Metabo packaging is 100% suitable for recyc-
ling.
Power tools and accessories at the end of their
service life still contain large amounts of
valuable raw materials and plastics which can
likewise be fed back into a recycling process.
These Operating Instructions are printed on
paper produced in a chlorine-free bleaching
process.
Battery packs must not be disposed of along
with domestic waste.
Return any faulty or exhausted battery packs to
your Metabo dealer.
Do not throw battery packs away in water.
tive 2002/96/EC on waste electrical and electronic
equipment and its implementation in accordance
with national law, electric tools that have reached
the end of their life must be collected separately
and returned to an environmentally compatible
recycling facility.

9 Accessories

A Charger
B Battery packs of varying capacities.
Buy only battery packs of the correct
voltage for your cordless tool.

10 Repairs

Repairs to power tools must be carried
out by a qualified electrician only.

11 Environmental Protection

Only for EU countries: Do not dispose of
electric tools together with household waste
material! In observance of European Direc-
ENGLISH
ENG
13