NordicTrack C2155 NTL07707.1 User Manual page 8

4. Set the Right Upright Spacer (79) on the Base
(83). Be careful not to pinch the Upright Wire
(38). With the help of a second person, insert
two 3/8" x 5" Bolts (6) with two 3/8" Star
Washers (9) into the Right Upright (78), and set
the Right Upright in the Right Upright Spacer. If
necessary, use a rubber mallet to make sure
that the Right Upright is fully seated in the Right
Upright Spacer.
Finger tighten the 3/8" x 5" Bolts (6); do not
fully tighten the Bolts yet.
Press a Base Endcap (77) into the Base (83).
5. With the help of a second person, carefully tip
the treadmill onto its right side. Partially fold the
Frame (56) so the treadmill is more stable; do
not fully fold the Frame yet.
Remove and discard the two indicated bolts (A)
and the shipping bracket (B).
Attach a Base Pad (81) to the Base (83) in the
location shown with a #8 x 1" Tek Screw (2) and
a Base Pad Spacer (13). Then, attach another
Base Pad (81) with only a #8 x 1" Tek Screw (2).
Remove the 3/8" Nut (8), the 3/8" x 2" Bolt (4),
and the shipping bracket (C) from the Base (83).
Attach a Wheel (84) with the Bolt and the Nut
that you just removed. Do not overtighten the
Nut; the Wheel must turn freely. Discard the
shipping bracket.
6. Set the Left Upright Spacer (76) on the Base
(83). With the help of a second person, insert
two 3/8" x 5" Bolts (6) with two 3/8" Star
Washers (9) into the Left Upright (74), and set
the Left Upright in the Left Upright Spacer. If
necessary, use a rubber mallet to make sure
that the Left Upright is fully seated in the Left
Upright Spacer.
Finger tighten the 3/8" x 5" Bolts (6); do not
fully tighten the Bolts yet.
Press a Base Endcap (77) into the Base (83).
With the help of a second person, tip the tread-
mill so that the Base (83) is flat on the floor.
4
78
79
83
5
A
81
2
6
6
77
9
8
6
77
9
38
B
83
56
4
13
84
81
2
C
8
74
76
83