Assembly - NordicTrack 5600 R NTL18940 User Manual

ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own phillips screwdriver
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
For help identifying the assembly hardware, see the PART IDENTIFICATION CHART on page 31.
1. With the help of a second person, carefully raise the
Uprights (69) to the position shown.
See the inset drawing. Insert one of the Extension Legs
(102) into the treadmill as shown. Make sure that the
Extension Leg is turned so the Base Pad (99) is under-
neath it. Note: It may be helpful to tip the Uprights (69)
forward and tap on the Extension Leg with a rubber mal-
let as you insert the Extension Leg.
Insert the other Extension Leg (not shown) in the same
way.
2. Press the Lock Knob Sleeve (70) into the left Upright (69).
Remove the Lock Knob (68) from the Lock Pin (74). Make
sure that the Lock Pin Collar (72) and the Spring (71) are
on the Lock Pin.
Insert the Lock Pin (74) into the Lock Knob Sleeve (70)
and the left Upright (69). Tighten the Lock Knob (68) back
onto the Lock Pin.
3. With the help of a second person, carefully tip the
Uprights (69) down as shown. Make sure that the
Extension Legs (102) remain in the Uprights.
Attach each Extension Leg (102) with two 1" Screws (17)
and a Base Pad (99) as shown. Note: Attach the lower
Screw (without the Base Pad) first.
With the help of a second person, carefully tip the
Uprights (69) back to the vertical position.
Note: A replacement Base Pad (99) may be included. Use
the Base Pad to replace any Base Pad that becomes worn.
, wire cutters
1
2
68
3
69
102
6
, and rubber mallet
69
69
71
72
70
69
102
99
17
.
102
99
74
99
17