Stihl MS 210 Service Manual page 61

11.2.2 Removing and Installing
– Remove the air filter – b 11.1.
: Pull fuel hose (arrow) off the
carburetor's elbow connector.
: Detach throttle rod from the
throttle trigger.
: Pull choke rod (1) out of choke
shaft (2) and switch shaft (3).
– On easy start machines, pull
carburetor forward a little.
60
: Disconnect fuel hose (1) from the
manual fuel pump, if fitted.
: Pull the hose (2) off the tank vent.
: Remove the carburetor.
: Take the throttle rod off the
throttle shaft.
: Remove the grommet with tank
vent from the adjusting screws.
: Slip the gasket off the studs.
– If necessary, remove the shim
from the studs.
Reassemble in the reverse
sequence.
– Fit the shim with its flat side
facing outward.
– Install a new gasket.
– Tighten down locknuts to 2.5 Nm
(1.8 lbf.ft).
MS 210, MS 230, MS 250