Stihl MS 210 Service Manual page 51

9.3 Handle Housing
– Remove the front handle –
b 9.2.
– Remove the fan housing –
b 8.2.
– Remove the muffler – b 6.1.
– Remove the carburetor –
b 11.2.2.
: Disconnect tank vent hose from
the stub.
1
2
: Pull the ground wire (1) off the
contact spring.
: Pull the short circuit wire's
contact sleeve (2) out of the
switch shaft.
50
: Ease the plug out of the annular
buffer.
: Pry the annular buffer out of the
engine housing.
: Pull the handle housing slightly
forward and push the manifold
through the handle housing
opening at the same time.
: Push the grommet out of the
handle housing.
– Pull the ground and short circuit
wires out of the bore.
: Pull the impulse hose off the stub
on the handle housing.
MS 210, MS 230, MS 250