Cadillac XT5 2017 Owner's Manual page 31

30 KEYS, DOORS, AND WINDOWS
If passive locking is enabled, the doors
may lock with the RKE transmitter
inside the vehicle. Do not leave the
RKE transmitter in an unattended
vehicle.
To customize the doors to
automatically lock when exiting the
vehicle, see Vehicle
Personalization 0 151.
Temporary Disable of Passive
Locking Feature
Temporarily disable passive locking by
pressing and holding on the interior
door switch with a door open for at
least four seconds, or until three
chimes are heard. Passive locking will
then remain disabled until
interior door is pressed, or until the
vehicle is turned on.
Remote Left in Vehicle Alert
When the vehicle is turned off and an
RKE transmitter is left in the vehicle,
the horn will chirp three times after all
doors are closed. To turn on or off, see
Vehicle Personalization 0 151.
Remote No longer in Vehicle
If the vehicle is on, with a door open,
and then all doors are closed, the
vehicle will check for RKE
transmitter(s) inside. If an RKE
transmitter is not detected, the DIC
will display NO REMOTE DETECTED
and the horn will chirp three times.
This occurs only once each time the
vehicle is driven.
To turn on or off, see Vehicle
Personalization 0 151.
Keyless Liftgate Opening
Press the touch pad on the liftgate
handle to open the liftgate if the RKE
transmitter is within 1 m (3 ft).
on the
Keyed Access
To access a vehicle with a weak
transmitter battery, see Door
Locks 0 35.
Programming Transmitters to
the Vehicle
Only RKE transmitters programmed to
the vehicle will work. If a transmitter
is lost or stolen, a replacement can be
purchased and programmed through
your dealer.
The vehicle can be reprogrammed so
that lost or stolen transmitters no
longer work. Each vehicle can have up
to eight transmitters matched to it.
Programming with Recognized
Transmitters
A new transmitter can be programmed
to the vehicle when there are two
recognized transmitters.
To program, the vehicle must be off
and all of the transmitters, both
currently recognized and new, must be
with you.
1. Place the two recognized
transmitters in the cupholder.
2. Remove the key lock cylinder cap
on the driver door handle. See
Door Locks 0 35. Insert the
vehicle key of the transmitter
into the key lock cylinder on the